Bit Stopper (E3\E4\Evolution CNC)

Description

Introducing the all new "
Bit Stopper
" for  Bob's "E3/E4", "Evolution", "Revolution" CNC's.
"PAUSING A CNC HAS NEVER BEEN EASIER"
Works on Bob's E3, E4 and the Evolution and NEW Revolution Series CNC!
(Not needed for Bobs larger KL Series CNC as that model comes with one)
The Bit Stopper is a Fully Assembled Emergency Pause and Resume Button product. The Bit Stopper is fully outfitted with the strongest neodymium magnets on the planet to keep you're Bits, Collet's and wrenches neatly and securely organized
at all times. The Bit Stopper comes fully wired, soldered and heat shrinked ready for use the moment it hits your hands.
It Magnetically attaches to any metal surface with ease or use the provided wood screws to secure it to any work bench, wall or
screw-able
surface. The cable can be run 3 ways. A hole is provided on either side of the Bit Stopper, or you may choose to drill a hole in your surface behind the Bit Stopper and run it out the back.
The Bit Stopper now gives you the ability to stop you're CNC in a split second with the press of a Large Red Button. Popped up tabs, hold downs in the way, or possibly you entered .44 instead of .044 and the cnc is boring to China. A quick tap of the Red button and the job is paused, allowing you to safely address the issue. A quick press of the green button and the CNC resumes
exactly
where it was paused. Should you pause, and then decide you want to cancel the project, use the mouse to click the stop button in UGS, which will kill the job.
The Wire with the RED TAPE goes in the "Hold" pin. The opposite wire (no red tape) goes in the RESUME pin on the arduino board on the back of the E3/E4/Evolution CNC. (Shown in the pictures)
Holes are provided on both sides of the Bit Stopper allowing you to position the cable in either a Right, Left or straight out the back direction.
The Bit Stopper is hand made in my shop with the upmost care and quality on each one. All wires and buttons are tested before going out.
FREE
Shipping
typically takes around 3-5 days in the United States. (Excluding Holidays and Sundays)
Satisfaction
Guaranteed
.
(
30)
Day return policy. Buyer pays for return shipping for a full refund.
Included:
1 Bit Stopper Fully Assembled (
Magnets, Emergency Stop button and Green Go button)
8ft
Wire already Soldered on and attached
(2) 1" wood screws
Not Included:
(Wrenches, Bits or Collets shown in some of the pictures attached to Bit Stopper)
Works on Bob's E3/E4 and the Evolution 3, Evolution 4 and NEW Revolution Series CNC!
Note:
To keep your cost down.. Cable colors may vary. (Typically Cables are Blue or Grey)..  FYI
I do use Global Shipping with Ebay to ship outside the country.
Note:
Missouri sales
incur
a 7.475% sales tax.
Free Shipping to the U.S.
Thanks